rf intall on a yakuza (gen3)

[LunchboxMischke]

ok guys 69RocketGC wanted to know how to rf his gen 3 yakuza so here it is

step one take out ur board and disconnect from everythinghttp://www.intimidatorowners.com/forums/picture.php?albumid=38&pictureid=817
step 2 plug it inhttp://www.intimidatorowners.com/forums/picture.php?albumid=38&pictureid=818
step 3 plug battery harness in and noid http://www.intimidatorowners.com/forums/picture.php?albumid=38&pictureid=819
step 4 install board and run the wires to where they will fit in your frame and screw board downhttp://www.intimidatorowners.com/forums/picture.php?albumid=38&pictureid=820
step 5 plug in eyes and put your gun back togeather
and step 6 turn ur hopper on and your gun no paint or air needed and shoot ur gun untill hopper and rf link up and your done

[Daigz525]

Good job! STICKY

[69RocketGC]

Thank you very much for this. Now I gotta grap the actual RF chip. I have the Magna Drive and the wire harness. Do you have to install something special into the hopper as well?

[Stewey956]

No, the RF receiver is already installed.