board settings

[lacer]

can some please post or give me a link to detailed descriptions on things like dwell, bip, bolt delay, etc.

[lacer]

also if someone knows the rendition(or better) settings could they please post or pm me.

[crankwalk]

This is what I was able to scrounge up for Rendition settings

BIP 2ms
Dwell 9ms
Bolt Forward/Bolt Delay 15ms
LPR at 80psi
Mbounce at 1
Debounce at 4
eyes set to "force" mode
overbore to .693 or .696 barrel

[Slimpikins976]

is that the best settings for an intimidator? or where to start from and tune to the individual gun?

[lacer]

they are the settings used by rendition so most likely only a place to start because there guns are probalby a different setup. and i believe they are for the gen4 timmy.

[big_daddy_d]

depends on what kind of board, ups, and all that other good stuff. Whats your current setup?

[lacer]

I have a Gen 3 RL Timmy, with frenzy 127.4, lpr volumizer, .689 barrel. also is it possible that my lp 68/4500 crossfire tank can't support the volume around 17 bps.

[crankwalk]

68/4500 LP tank should be fine for 17bps and above unless the tank regulator is defective - are you experiencing any problems?

I'd go with the Rendition settings - they were set up for a Gen 3 marker

[jrmiller]

This is what I was able to scrounge up for Rendition settings

BIP 2ms
Dwell 9ms
Bolt Forward/Bolt Delay 15ms
LPR at 80psi
Mbounce at 1
Debounce at 4
eyes set to "force" mode
overbore to .693 or .696 barrel

thats the same settings i use. i use a .689 bore though. we have small paint at our field:tup: