help with my frenzy 127.5 c settings please

[zikatz]

Hi i just got a Timmy with a frenzy 127.5c board but i am having some chop issues. I thought maybe it was the settings (such as delay and such) What settings do you have your board set to?

[crankwalk]

Try this

BIP 2ms
Dwell 9ms
Bolt Forward/Bolt Delay 15ms
LPR at 80psi
Mbounce at 1
Debounce at 4
eyes set to "force" mode

[zikatz]

Thank you i will definitly test that out. one other thing how do you remove the hose lines from the frame to body? I tried pulling gently but i think i may have made small tares in the hose.

[crankwalk]

You have to pull the hose firmly, and straight (not at an angle, or you may also break a barb). Some folks use needle nose pliers for better grip. If you made small tares in the hose, you may have a leak. Depending on where they are (e.g. if right at the barb) you may be able to snip the end off and reinstall if there is enough length. Otherwise you may need new hose.

[IRStookmySpyder]

zikatz- I take a small jeweler's screw driver and just work the hosing off of my barbs when I need to take them off, and then it doesn't do any damage and I don't need to replace them.