toolittletoolate
06-05-2009, 10:10 PM
OK, so I was putting some paint through my Marq 6 today. Shot a hopper full, refilled, fired 1or2 balls, then nothing. Board will only flash WHITE. Have tried 3 fresh batts, no change. I pull the trigger nothing, I think my micro switch is bad. I tried both the rubbing alcohol and air trick, nothing. My reason to believe its the switch is when working fine when you hold down the trigger and turn the board on it turns the eyes OFF, and flashes WHITE. I have the stock MARQ board, so no programing just dip switches. I called BLAST and talked with Matt, no techs in till Monday. Matt didn't tell me one thing that was helpful, told me to check my pressures, and that the noid wont click unless its aired up:facepalm:. So anyone have any ideas?