milling

[gajones06]

who does some good milling an relatively cheap?

[straptrams91]

Elia.. otherwise try contacting CS900 from pbnation to see what he can do for you

[gajones06]

pm'd cs900 an speedcustoms but he isnt taking anymore work...a waiting a pm from cs

ellia is a little costly..its a 200 dollar minimum..an when i went to fill out a quote request he didnt have timmys listed as an option.

[straptrams91]

on his website he states he will mill them, but on a basis of a quote, just shoot him an email. you arent going to find much under 200$ as the prep and setup to mill the body is somewhat extensive and is what takes the majority of the time and thus increases the cost. milling isnt cheap my friend

[gajones06]

cs900 wont either..anyone else have any other ideas??

[moon]

you might check with your local pro shop i know ours will run a mill for 60 an hour

[gajones06]

my local pro shop consists of two table a computer three pallets of paint an a few tippmanns for sale