2k2 frame with 2k5 internals

[moon]

ok i have a 2k2 timmy just laying around and i also have a 2k5 virtue board i was looking at it and was thinking it wouldnt be to hard to mount the board just a drimal to shave off the little himp where you skrew the board in cus the micro switchis too far up and then drill a hole and tap it. it would be all good but my problem is the membrain pad

so my question to you guys would be
how could i mount the membrain pad

i realy dont want any one saying this is pointless cus i kinda know that but i want to do it so dont post on this thread if you are just going to be negitive

[oldironmudder]

THIS IS POINTLESS!!!!!

HAHA, not really. Someone else did this here but his pictures or video is gone now. I plan to put my Tadao board in my wife's Texas Storm & buy me a new OLED board. Ive set the M6 in the 2002 frame & figured out i do need to take some material off where the board screw is. But I can remember right now about the screw for the microswitch. Oh well, I will do it one day. The membrane pad, easiest way would be mill the back of the frame like on 2005 frames. I plan to do something a little different but will still work out right.

[moon]

well i i was thinking of cutting out a spot for the membrain pad and then welding a small rod or palte on the front and back

[battlechaser]

If you want the sleeper look, pick yourself up a WAS 2.9 board. It has all the features you're looking for, and is meant for a 2k2 based gun.