nycflip22
02-16-2008, 03:11 AM
(As requested by crankwalk lol)
Hey guys, so I got my Protege back from BLAST.
They updated Frenzy 3.0 stock board.
They sent it back with a new "quick start manual" for the board. "Bob Long Frenzy 3.0 Board Instructions".
The only difference is dip switch 3. Programmable ROF (Rate of Fire)
I will type it out for anyone interested.
To check ROF setting:
1. Power off board.
2. Set dip switch on (On) position.
3. Pull and hold trigger.
4. Power on board.
5. LED will turn white.
6. Release Trigger.
7. LED will turn off and then flash the current BPS setting.
8. LED will then turn green awaiting your response.
9. Pull trigger to set desired BPS.
> 1 pull = 11 BPS
> 2 pull = 12 BPS
> 3 pull = 13 BPS
> 4 pull = 14 BPS
> 5 pull = 15 BPS
> 6 pull = 16 BPS
> 7 pull = 17 BPS
> 8 pull = 18 BPS
> 9 pull = 19 BPS
> 10 pull = unlimited BPS
10. Wait 3 seconds after last trigger pull.
11. LED will flash back the ROF setting you programmed and board will then power itself off.
12. Check ROF setting to see if correct.
13. Set dip switch back to (Off) position then reboot your board.
Hopefully this hasn't already been posted cause then I wasted my time type it all out :P
*Special thanks to Joe from BLAST for tech'ing and updating my Protege! I'm glad to have it back.
http://i3.photobucket.com/albums/y88/nycflip22/paintball/IMG_0980MediumSmall.jpg
Hey guys, so I got my Protege back from BLAST.
They updated Frenzy 3.0 stock board.
They sent it back with a new "quick start manual" for the board. "Bob Long Frenzy 3.0 Board Instructions".
The only difference is dip switch 3. Programmable ROF (Rate of Fire)
I will type it out for anyone interested.
To check ROF setting:
1. Power off board.
2. Set dip switch on (On) position.
3. Pull and hold trigger.
4. Power on board.
5. LED will turn white.
6. Release Trigger.
7. LED will turn off and then flash the current BPS setting.
8. LED will then turn green awaiting your response.
9. Pull trigger to set desired BPS.
> 1 pull = 11 BPS
> 2 pull = 12 BPS
> 3 pull = 13 BPS
> 4 pull = 14 BPS
> 5 pull = 15 BPS
> 6 pull = 16 BPS
> 7 pull = 17 BPS
> 8 pull = 18 BPS
> 9 pull = 19 BPS
> 10 pull = unlimited BPS
10. Wait 3 seconds after last trigger pull.
11. LED will flash back the ROF setting you programmed and board will then power itself off.
12. Check ROF setting to see if correct.
13. Set dip switch back to (Off) position then reboot your board.
Hopefully this hasn't already been posted cause then I wasted my time type it all out :P
*Special thanks to Joe from BLAST for tech'ing and updating my Protege! I'm glad to have it back.
http://i3.photobucket.com/albums/y88/nycflip22/paintball/IMG_0980MediumSmall.jpg