timmy wont work

[jamrens@comcast.net]

i got my 2k2 in a trade and it worked fine till i took it apart to clean it then i played one game with it, then it was acting like the noid was starved for air. so i checked for pinched hoses, lubed the lpr with dow 55 and the tried 2 hprs on it. i took the advise and bought a new noid. after i installed the new noid the ram and bolt wont come back its kinda stuck in forard position. i bought a noid for an alias, the hoses are ran rite, help a bother out i dont want to send it to blast i want to learn how to work on my own stuff.


Whit

[mcsquid86]

there is a button on the noid, press it see if it cycles.

[jamrens@comcast.net]

got it to work but now it wont shoot with eyes on

[Squirlly]

Looks like it's time to inspect the eyes wires.

-Tim

[Slimpikins976]

most common problem with eyes, is they are dirty. If your sure they are clean you have only a few things to check.....
1. are they plugged all the way in to the board and wiring harness?
yes, ... then
2. are any of the wires pinched? or show any dammage from being pinched previously?
No.....
3. Make sure your eyes are aligned correctly.( sometimes you need to slap a piece of plastic or cardboard behind an eye to hold it into place .
yes....
4. swap out boards and see if your board is bad.

this is all I can think of bro. I clean my eyes with rubbing alcohol before and after every time my gun goes out.... works wonders!!! tell us if this changes anything

[jamrens@comcast.net]

the paint i was using is real small i had to use the smallest back to my pipe kit when i shot it threw my cocker i think it was rolling back

[Slimpikins976]

If your gun is running on a two eye system, you can do What I do to test eyes.... Get your barrel Squeeegie the big furry type on a stick , double headed and put it down your feed tube from the top of your gun where the balls come in.
Next turn on the gun after it is gassed up and pop off a few rounds. I do this to train and practice with my Timmy. The barrel swab breaks the plane of the laser and you gun should shoot just as fast as it would with a constant string of paint.
see how this works and post what you found, hopefully the paint was the issue but small bore paint shouldn't make that much of a difference. In my experience smaller bore paint should make no difference.

[jamrens@comcast.net]

its a small ball i tried this and it worked great thanks guys