broken 2k6 torpedo

[pbfrenzy44]

I have a 2k6 torpedo that is working as a gas through grip. tested it on a gauge and is was all the way up to 850. I took out the washer and turned it around to see if that would do anything and i replaced the oring on the piston and still nothing worked. So is it probably the washer and i'll have to get a new one?

[crankwalk]

I would change all the o-rings inside the reg, lube the piston ring and brass nut ring but not the white pin valve ring and then make sure the brass nut is screwed in very snug when you're done - use a socket wrench. Also replace and lube both outside o-rings (the skinny and fat ones near the end of the LPR that screws into the body)

[pbfrenzy44]

i found out that it was the 90 degree fitting was actually in the wrong hole, it was where the gauge was supposed to be. so i switched it around and it works now

[crankwalk]

Wow... that's an unusual one! I'll have to remember to have people check that if they are having issues :D

glad you worked it out