I need better efficiency >>>

[hype]

Like the title says , I need to get better efficiency out of my gun it has the following upgrades to it, maybe I'm not looking deep enough, Hybrid regs, yes both of them, high flow barbs , orange bolt, Ans ram ,it has a kila board with dwell set up @ 8.5, with this set up I'm only getting about 500 to 600 shots off per Lp4500/68 stubby, any help would be appreciated, any help , any help:cheers:Thanks ...........

[crankwalk]

Sounds like there might be a slight leak somewhere - I'm going to ask the obvious question if you've recently lubed and/or replaced o-rings in the common places - ram, poppet, regs

[hype]

found a small nick on the front o ring of my ram sleeve again, is there anyway of avoid these when installing or removing the sleeve??? I think it's the front body hole, that's causing issues here,when I put in the sleeve of course..........I think:cheers:

[Megatron]

when re-installing, go in from the front SLOWLY , and make sure to be generous with the dow 55 on the orings, this will help slide them past the front body hole with out damaging them:tup::tup:good luck

[crankwalk]

what Megatron said - the other tip I would have is to slowly twist the sleeve back and forth (like, clockwise and counterclockwise) as you are pushing the sleeve into the body from the front.. this will also help keep it from snagging.

[hype]

Thanks guys , I appreciate it !!!