new press fit feedneck and ano question

[bobcat_balla08]

well on my storms body there has obviously been a new feedneck base press fit on, and with this they use some form of epoxy when they press fit on a new one. I was just wondering if any one has had any problems anodizing their marker after a new feedneck was press fit onto it

[oldironmudder]

Taking it out then cleaning it up should yield good results unless the person pulling the neck cant do it or the ano person sucks. Call Blast.

[bobcat_balla08]

so if i pull it out and have it ano'd will it be able to be pressed back in without causing any damage to the ano?

[oldironmudder]

There is a chance you can get it out yourself. If the "glue" is weak, you could turn it until it frees up & take it out then clean it up.

IF you put it back in you should be able to keep from messing anything up unless your a ratard. Keep the "glue" where it needs to be & dont get stupid with any of it.

[bobcat_balla08]

meh only way i think ill get it out is if i get some pretty good heat on it. and the jerk off who glued it in before either got glue on the threadings of the feedneck or glued on the feedneck as well so i think it might just be worth it to get a new base

[oldironmudder]

There should not be any threading. Hole in body then the feedneck base.

[bobcat_balla08]

no like the feedneck is glued onto the feedneck base, i think i just need to call blast