Help empire 2 will not fire

[jay814u]

when I set lpr between 75 & 80 there is just enough air to cycle the bolt i have to turn lpr up past 150 to get it to shoot any ideas why this is happening :(

[pbfrenzy44]

whats ur reg pressure at? if its low, turn it up and keep the lpr at about 75 and try that.

[jay814u]

doesnt seem to make a difference if i adjust hpr only helps when i turn up the lpr but its way to high

[lopez17]

1. Check the LPR base o-ring (the square o-ring) and relube/replace.

2. Check your HPR and LPR pin valves for damage.

3. Replace both your HPR and LPR pison o-rings.

4. Check your poppet and ram o-rings for wear and damage. Replace if needed.

[jay814u]

ok i checked everything replaced all o-rings still doing the same thing. not sure what else i can do

[jay814u]

i also just hit the reset button on the noid an it did fire but that was it any ideas what might be going on with it

[crankwalk]

Sent you a PM but try upping the dwell some more and see what happens - and yes please keep the LPR at under 75PSI :)

[jay814u]

Finally figured it out i removed rear air barb block and must have had something blocking air gun shoots fine now thanks for all the help:tup:

[Stewey956]

Finally figured it out i removed rear air barb block and must have had something blocking air gun shoots fine now thanks for all the help:tup:

Sweet.

[crankwalk]

Yeah I'm glad to hear you figured out the problem and it was a simple fix. I'll have to remember that next time someone has tried almost everything to get their marker to fire :D

It is strange though that the marker fired fine when you hit the red button on the noid. A severe blockage such as the one you described should have rendered the noid incapacitated regardless of the way it was triggered.

But in any case glad to hear it is fixed!